LattePanda board Cooling Fan

From All for Raspberry Pi, Arduino, Lattepanda, Orange Pi, Pine64 | by Geekworm
Jump to: navigation, search


lattepanda cooling fan sku:448266
lattepanda cooling fan sku:448266

Overview

Aluminum Heatsink Cooling Fan for LattePanda

If you want to know more about LattePanda, please refer link: LattePanda_board

This cooling is suitable for lattepanda acrylic case, as link: LattePanda board acrylic case

INTRODUCTION

Is your LattePanda running hot and throttling?

This heat sink and fan combo will cool the CPU for smooth performance.

The fan keeps the unit running at a stable temperature. The 2-Pin jumper wire makes it easily to connect with the CN2 headers on the board.

This fan is low noise and has a thermal pad on the back that can stick on the metal shield on the board. With its aluminum casing, heat from CPU will be absorbed fast, giving you better performance. This is a simple and effective way to make the LattePanda cool!

Note: Please pay attention to wire polarities Red -> 5V Black -> GND

Fan Assemble.jpg

SPECIFICATION

  • Operating Voltage: 5v
  • Operating Current: 0.14A
  • Rated Speed: 6500 RPM
  • Cable Length: 20cm
  • Interface Type: 2.54mm 2-Pin DuPont Female Connector
  • Dimension: 34.5 * 34.5 * 7.2 mm/1.36 * 1.36 * 0.28 inches
Add your comment
All for Raspberry Pi, Arduino, Lattepanda, Orange Pi, Pine64 | by Geekworm welcomes all comments. If you do not want to be anonymous, register or log in. It is free.